After hard work, roll cage is finally painted. It looks not bad, not good. Assuming circumstances, I personally think, that result is very good (no time to really work on it, no light, no expierence with two component paint, HVLP spray gun and high performance compressor). From objective judgement side, I can tell that result is about 6 from 10. Some shots of finished result:
Closer look:
So now its time to pull engine out (to change gearbox, flywheel, clutch). Like always, I will do it by dropping engine and gearbox to basement. To achieve this - you need to dismount everything, and leave bare engine. So it started like this:
And in the evening all the hoses, and fluids were out:
Closer look:
So now its time to pull engine out (to change gearbox, flywheel, clutch). Like always, I will do it by dropping engine and gearbox to basement. To achieve this - you need to dismount everything, and leave bare engine. So it started like this:
And in the evening all the hoses, and fluids were out:
No comments:
Post a Comment